GRC products, GRG product manufacturing process

The two kinds of prefabricated components have the same process at the time of manufacture. The difference is that only one kind of raw material is cement and one is gypsum. However, the difference between the two products is still quite large. Compared to the two products, they are used indoors and the GRG products have various functions. To be better, detailed product parameters can refer to other materials or consult manufacturers.

Since GRC products and GRG products can be processed seamlessly and can be molded, most of GRC products and GRG products are shaped and changeable in shape. Therefore, the structure of the bottom layer will follow the detailed shape change and cannot conform to certain specifications. Structured approach to express. However, due to its large weight, the underlying structure is generally made of steel skeletons, which are connected by GRC and GRG reserved pendants.

Second, the process

1, construction process

Measure, pay off line → GRC, GRG plate processing map typesetting processing → steel keel manufacturing device → keel inspection → device GRC, GRG plate → exterior finish processing

2, the main construction methods

Because the shape of GRC and GRG products are diverse and the shape of the curved surface is complex, the first device process is still a dry hanging device through a steel structure. The primary process flow is relatively simple. The primary difficulty or main point lies in the manufacturing of GRC and GRG plates and the manufacture of skeletons. Accurate match with the two.

1, GRC, GRG density is less than stone, but the general thickness will be between 20-60mm, so the same area of stone and GRC, GRG's weight is the same, in the skeleton design can refer to the stone dry hanging process.

2. After the requirements of steel frame skeletons have been calculated, general GRC and GRG ceilings need to set up the steel structure conversion layer. The skeleton of the wall plate can use square pipe, channel steel, etc. as the vertical keel, and the angle steel transverse keel as the connecting device.

3. The joints between the plates of GRG products can be overlapped, left seamed or seamlessly processed.

GRG products can be used in special-shaped, perhaps repeatable shapes of ceilings, walls, etc. For example, some modular ceilings, access ports, etc.

GRC and GRG data device methods and processes are basically the same. However, the functions of the two data types are still quite different. At present, most of the GRG products are used in indoor space. GRC products are mostly used in exterior wall components. Compared with GRG products, the cost is higher than that of GRC.

With respect to its installation process, it is necessary to rationally divide the plates according to the characteristics of GRG modeling, and through the cooperation with the manufacturers, jointly determine the processing and manufacturing of the products and the device process.